CISCIO NEW UPDATED: New Updated 350-080 Exam Questions from Braindump2go 350-080 PDF Dumps and 350-080 VCE Dumps! Welcome to Download the Newest Braindump2go 350-080 VCE&PDF Dumps: http://www.braindump2go.com/350-080.html (394 Q&As)
Instant Download 350-080 PDF Files! New Updated 394 Exam Questions and Answers help 100% Exam Pass! 350-080 Certification Get Quickly!
Exam Code: 350-080
Exam Name: CCIE Data Center Written Exam
350-080 Dumps,350-080 Exam Dumps,350-080 Brainfump,350-080 Questions,350-080 VCE,350-080 PDF,350-080 Actual Test,350-080 Study Guide,350-080 Book,350-080 CCIE Data Center Written Exam,350-080 Test
Which PIM mode is supported in Cisco NX-OS?
A. sparse mode
B. dense mode
C. sparse-dense mode
D. dense-sparse mode
Refer to the exhibit. Which configuration command (or commands) will produce the output that is shown in the exhibit?
A. no feature igmp
B. no feature igmp snooping
C. vlan 201
no ip igmp snooping
D. vlan configuration 201
no ip igmp snooping
E. interface vlan 201
no ip igmp snooping
Refer to the exhibit. The following message output was displayed while configuring PIM on Nexus 7000. Which command should be configured on the Cisco Nexus 7000 Series switch to allow the desired configuration?
A. feature multicast
B. feature pim
C. ip multicast-routing
D. ip pim routing
Which two statements about FCIP Tape Acceleration are true? (Choose two.)
A. FCIP Tape Acceleration enables time stamp control on an FCIP interface.
B. The Cisco MDS switch proxies a transfer ready to signal the host to start receiving data.
C. FCIP Tape Acceleration uses TCP window management and a sliding window for flow control.
D. FCIP Tape Acceleration reduces each I/O processing time by two RTT.
E. FCIP Tape Acceleration only supports the read acceleration.
Refer to the exhibit. Given the displays from MDS-1 and MDS-2, which two options describe what will happen when they attempt a zone merge for VSAN 120? (Choose two.)
A. The zone merge will complete with no warnings and each switch will contain three zones.
B. The zone merge will fail because the zone set members are not identical.
C. The zone merge will prompt the administrator to add zones ucs-1 and ucs-2 to the switches where they are missing.
D. Zone merges are not permitted when running enhanced mode zoning.
E. The zone merge will fail because the active zone set names are not identical.
F. The zone merge will complete, but the administrator will be prompted to choose which zone set to make active.
Which of the following is an advanced networking function performed by VEM?
C. VSAN creation.
D. VLAN pruning.
Refer to the exhibit. Which three statements about the exhibit are true? (Choose three.)
A. The differentiating characteristic of the Cisco Nexus 1000V Series is that it does not run
Spanning Tree Protocol. This characteristic may seem to be a significant departure from other Ethernet switches, which might potentially cause catastrophic network loops. However, in reality, the Cisco Nexus 1000V Series implements a simple and effective loop- prevention strategy that does not require Spanning Tree Protocol.
B. Because the Cisco Nexus 1000V Series does not participate in Spanning Tree Protocol, it does not respond to BPDU packets, nor does it generate them. BPDU packets that are received by Cisco Nexus 1000V Series Switches are dropped.
C. The Cisco Nexus 1000V Series uses a simple technique to prevent loops. Like a physical Ethernet switch, the Cisco Nexus 1000V Series Switch performs source and destination MAC address lookups to make forwarding decisions. The VEM applies loop- prevention logic to every incoming packet on Ethernet interfaces.
D. The Cisco Nexus 1000V Series uses a simple technique to prevent loops. Like any logical Ethernet switch, the Cisco Nexus 1000V Series Switch performs source and destination MAC address lookups to make forwarding decisions. The VEM applies loop- prevention logic to every incoming packet on Ethernet interfaces.
E. Because the Cisco Nexus 1000V Series participates in Spanning Tree Protocol, it responds to BPDU packets, and it generate them. BPDU packets that are received by Cisco Nexus 1000V Series Switches are dropped.
Which two options correctly display IOM-to-Fabric Interconnect connectivity? (Choose two.)
What are the two FEX connection modes? (Choose two.)
A. hard-pinning mode
B. soft-pinning mode
C. port channel mode
D. physical-pinning mode
E. vlan pinning mode
What is the default burst in a LAN QoS policy?
Latest 350-080 Questions and Answers from Cisco Exam Center Offered by Braindump2go for Free Share Now! Read and remember all Real Questions Answers, Guaranteed Pass 350-080 Real Test 100% Or Full Money Back!
FREE DOWNLOAD: NEW UPDATED 350-080 PDF Dumps & 350-080 VCE Dumps from Braindump2go: http://www.braindump2go.com/350-080.html (394 Q&A)